Get Support

123-456-789-10

TR | EN | RU | ES | AR

Speed-X Flash - Powder Formed Leak Stopper With Fast Setting Properties

Description
Speed-X Flash is ready-to-use, powder form leak stopper with fast setting properties. It is applied in powder form without mixing with water. It is not a waterproofing material. Waterproofing application is required after stopping the leakage by Speed-X Flash.
Usage Areas
• Speed-X Flash which provides waterproofing by curing in 2-5 seconds to the point where it contacts with water is used indoors and outdoors; on all kinds of mineral based surfaces such as concrete, plaster, screed, briquette, etc.
• Used for blocking existing water leaks before waterproofing.
• For stopping active water leaks and to dry the surface waters and moisture on the surface.
• Used to quickly cut off water that has leaked or pressurized from cracks and gaps.
• Used for the inner insulation of basement floors.
• It is used for stopping or blocking pressurized water leaks, strong water leakages and capillary water leaks before sealing.
• Used for immediately stopping leakage on foundation walls, basements, tunnels, water deposits, elevator pits and damaged water pipes.
• Used at urgent sewage connections.
Advantages
• Easy and fast to apply.
• It is an ideal supporting material for emergency insulation applications.
• The mixture is made of fast cement, chemical and polymer additives.
• Speed-X Flash expands to the opposite direction of water flow and does not shrink and crack after it has cured.
• It does not contain soda or chlorine, so it does not rust steel reinforcements and provides excellent adherence to any kind
of mineral based surface.
• It freezes rapidly and stops the flow of water in a very short period of time.
• 15-20 minutes after application all types of waterproofing material can be applied on it.
• It is applied from opposite direction of water flow (negative water pressure).
Application
Speed-X Flash is applied in powder form. It must not contact with water before application. Gloves should be used during application.
Take some powder in your hand, squeeze it and push it in the crack or hole towards the source of the active water leak. Hold it until Speed-X Flash hardens and water flow is ended. Negative waterproofing (with Permo Chim Crystal) is required immediately after the Speed-X Powder application. Speed-X Flash is not flexible.
Cracks can be occured in areas exposed to vibrations where motion or seating is observed.
Consumption
Approximately 2 kg Speed-X Flash for each 1 liter gap.
Packaging
5 kg Plastic Pail
75 Pails / Pallet

Appearance                              : Gray powder
Density                                     : 1,2 – 1,3 kg/lt
Application temperature range    : +5°C to +35°C
Application time                         : 2 – 5 seconds ( at +20°C)
Compressive Strength               : 30 minutes ≥ 7 N/mm2 (TS EN 12190)
                                                 24 hours ≥ 10 N/mm2 (TS EN 12190)
                                                 28 days ≥ 30 N/mm2 (TS EN 12190)
Türk Malı
Türk Ak
İzoder
Suder
Szutest